Z Bar Flashing Installation

If only the surface is damaged.

Z bar flashing installation.

Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if. The seat dimension 3 8 in corresponds to the siding thickness. Place the z flashing into position on top of the casing. Install the first length of z flashing.

Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing. Galvanized steel unless specified. Designed for roofing applications. The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.

Backleg made of 28 gauge galvanized steel. Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver. Galvanized steel z flashing is made from 28 gauge galvanized steel. Item 3807 model 5504900120.

When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the. The z bar is available in 018 033 043 054 thickness of steel. Steel z bar flashing with 2 in. Z bar design easily accommodates rigid insulation.

Subject to inquiry for availability. Flanges are available in lengths of 1 1 1 1. Suitable for residential or commercial use. Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.

Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding. Thd sku 686080. Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud. Check out our recommended tools right here.